This project consisted of the following:

Deconstruction and preparation of this bathroom.
Remove the shower faucet trim pieces.
Remove the fiberglass tub enclosure and expose the stud walls.
Remove the existing tub/shower faucet.
Reconstruction phase was as follows:
Access the foundation and modify drain system to install shower drain.
Make all modifications to the water supply lines needed.
Installation of the two new shower faucets.
Install backer board and tape and float with thin-set mortar.
Construction of the cinder block shower bench.
Installation of 12"x 12"  Country tile on all shower walls.
Install 3" wide stone feature strips in tumbled traverine mosiac.

Trim tile color is Noce tumbled travertine in  2” x 4” caps and feature strips. 
Install 2” x 2”  anti-slip Noce travertine on shower floor.
Grout out all tile work in Sandstone.
Installation of the faucet trim and shower heads in nickle.

Install the shower door in brushed nickle. This shower glass enclosure consists of a pivot shower door and a fixed panel.  The glass is  has a factory treatment to resist water stains and  to be maintenance-free.  It also compliments the tile design.

Installation of the bathroom floor tile was done in an off-set  pattern. .

The countertops were replaced with solid surface countertop with built-in sinks.

The vanity faucet was also replaced with 2 8" center brushed nickle faucets. 

The mirror was replaced with 2 framed mirrors.

Two vanity lights were installed.

A comfort height commode was also installed. 

                       ENJOY THE SLIDES AND GIVE US A CALL AT 832.202.8453